Load securement on flatbed....
#13
When you think you have enough chains or straps on the load, add a couple more. At least till you know the loads and what they require.
Be careful asking for advice, some drivers take short cuts. If you have any doubts, add more, as you are ultimately responsible for your load. If you ever do lowboy,here is how to secure an excavator. 4- 1/2 chains and binders at 4 corners and a 3/8 chain and binder over the boom. We lowboy drivers don't mess around with that lightweight 5/16 stuff. :lol:
#14
When you get into something new, take your time and really look the load over before you start your securement. When securing a vehicle, ALWAYS have your chains pulling in opposite directions on each end. Otherwise, your cargo may move one way or another. The last thing you need is a vehicle moving on the trailer.
#15
Member
Join Date: Oct 2005
Posts: 162
That rub rail requirement comes with caveats:
"All tiedowns and other components of a cargo securement system used to secure loads on a trailer equipped with rub rails must be located inboard of the rub rails whenever practicable" Whenever practicable. That's from the FMCSA's Cargo Securement Rules PDF version, P.3. One example might be a load wider than the trailer.
#18
Senior Board Member
Join Date: Oct 2006
Posts: 2,079
Originally Posted by chuck3507
That bugs the hell out of me when I see another flatbed withnthe straps hooked on the outside of the rail!!!!
I put them inside when I can, but to get all bent about it? Well that's kinda funny. Actually one of our trailers has bolt on winches and I put the straps outside the rub rail on that one all the time. It I don't, the strap pulls against the inside of the rub rail and breaks the welds. |

