[rank]

Originally Posted by rank

There may be easier mapping software to plan a route with, but I haven't found it yet. Click and drag is what I like about S&T. I will agree that until I installed "keys", I could not use it for navigation at all....just couldn't pan and zoom easy enough. Keys turns the +/- keys on the laptop into zoom in/zoom out and it used the arrow keys to pan up, down, left and right. I applied little foam stickers to each of these 6 keys so they are "braiiled". Now pan and zoom without looking.

here's a camera phone pic of my setup

[beaner]

I drive a new 587 pete that has the gps built in to the dash touch screen also is the screen for the stereo ant is wacked waiting to get back in to the shop to get it replaced it swears im in indy driving and i dont go that far east even says low bridges in kansas when there's no bridge for a 100 miles

[SamIam_Murphy]

Originally Posted by Walking Eagle

Truckstop overlay for Streets and Trips

Welcome to Truck Stops Plus

Thank you for the information Walking Eagle!

And thanks to all of you who are recommending Streets & Trips, if it is working as well for you all as it is for me I may be able to convince my company to continue using it!! I find S&T invaluable in mapping my destinations, and it rarely fails to guide me to the correct place. If it doesn't seem right I can usually figure out where it went wrong and not drive more miles than necessary.

[jmlloar]

Originally Posted by Malaki86

CoPilot is a better navigation program to be used while driving.
Also, CoPilot *IS* truck-specific, so less likely to have problems with it than Streets, which can & will get you into problems.

Thats a load. Copilot is a useless piece of crap. Very few times has it sent me down the correct route. It has tried to turn me down one way streets in the wrong direction. Doesnt show streets that are there. Has tried to run me under low clearances. And just to see what would happen I left it set for pulling a 53' 102" trailer and set it to route me to my destination (which by the way I was running bobtail to get an empty) and it ran me through a little town which was clearly a non truck route and turned me onto a side street to my pickup location which was marked no trucks, this turn had to be backed up in slightly to make it with just the tractor. Now remember the routing is set to be that I'm pulling the 53 102. Yeh right, copilot is the biggest piece of crap on the market. I'll stick with the garmin I got better directions with it and mine isnt even a truck one.

[Freedhardwoods]

This is a handy little add-on that will work with several of the programs mentioned in this thread.

Low Clearance GPS Data

[Fredog]

Originally Posted by allan5oh

Do any of the units have truck routes for Canada? I know Rand Mcnally does not.

Garmin 465t does

[rank]

Originally Posted by Freedhardwoods

This is a handy little add-on that will work with several of the programs mentioned in this thread.

Low Clearance GPS Data

Thanks Free. I'm still running MS Trips 2007 and the site says there is no guarantee of backwards compatibility from 2009. But for $15, I think I may still give it a try. I'm still running 2007 because I've been told I will lose all my manually entered destinations and no truck routes if I upgrade.