What kind of cfm (at 90 psi) is required for doing heavy truck wheels? My impact seems to prefer 130 psi or so to break 500 lb ft loose. Normally we use the truck air compressor, but that takes a while of waiting even in between each nut.
Is 60 gallon good enough or do we need 120(or bigger)?
Shop will have 220, in floor heat is electrical (10,000W if I'm not mistaken). Nothing is installed yet except the in floor heat, so I'm wondering what the best direction is. Should I reserve one plug for 50 amps for the air compressor? Or maybe hard wire it.