MBN cat question
 

now that i finally got the truck i have a few questions.


backround: its a ex ryder lease truck. truck is definitely from the west coast. frame is PERFECT. overall the truck is clean and pulled air freight.

specs: 04 columbia 70 condo sleeper, 10 speed 3.73 rear, 22.5 lopro's, C15 435 hp MBN motor.


now i dont know if this is the cat ecu or what. the jake will NOT work if the cruise switch is on. however it will with the cruise switch on and foot brake applied for about 3 seconds. cruise switch off its fine.


other then that this truck runs dead on 100%. had the truck at ryder this morning to have a fedreal inspection done (very long story on this), the tech was impressed with how clean the truck is, all brakes are 95% or better rear axle is 60% on tires which sucks because the front axle is 95%. the tech said the truck has little to no blow by either. i have the past records from when the truck was new with ryder, the 2 most major things were the 5th wheel was rebuilt and turbo was done about 90k ago, oh and exhaust is brand new on the truck, flex pipes, both mufflers and stacks. not too bad for $24k

The jake is working just like Ryder had the ECM set for it to work. You can change it if you want...or just leave it alone.

great thanks!