|
|
03-02-2010, 11:04 AM
|
Rookie
Thread Starter
Join Date: Nov 2009
Location: Conyers, Geprgia
Posts: 2
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Equipment needed for Flatbed
Need advice on equipmnet needed for new O/O flatbed trailer? how many traps, chains, straps, and any other equipment need to start flatbedding. any advice will be helpful
|
03-02-2010, 11:45 AM
|
Administrator
Site Admin
Board Icon
Join Date: Feb 2005
Location: Tennessee
Posts: 17,097
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Quote:
Originally Posted by claydub2
Need advice on equipment needed for new O/O flatbed trailer? how many traps, chains, straps, and any other equipment need to start flatbedding. any advice will be helpful
|
It depends on the type of freight you plan on hauling. I would start with the following:
2- steel tarps
1-lumber tarp
10- 3/8" 70 grade chains
10- binders
10- straps
5- sets of coil racks
10- pieces of beveled 4" x 4' hard wood
10- pieces of belting
20 - edge protectors for straps
20 - edge protectors for chains
50 - 21" bungee straps
1- bulkhead or headrack.
This will get you started. You can add more as you need them, but this should be most of what you should need on a daily basis.
|
03-02-2010, 10:50 PM
|
Board Icon
Join Date: Oct 2005
Location: Been there and gone...
Posts: 6,412
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 1 Thread(s)
|
Quote:
Originally Posted by GMAN
It depends on the type of freight you plan on hauling. I would start with the following:
2- steel tarps
1-lumber tarp
10- 3/8" 70 grade chains
10- binders
10- straps
5- sets of coil racks
10- pieces of beveled 4" x 4' hard wood
10- pieces of belting
20 - edge protectors for straps
20 - edge protectors for chains
50 - 21" bungee straps
1- bulkhead or headrack.
This will get you started. You can add more as you need them, but this should be most of what you should need on a daily basis.
|
Started is about right. After you're into it a while, you will likely increase your number of chains, binders, and straps. The number of "bungee's" may go up to a hundred or better. You never seem to have enough of them, and you're continually replacing the ones that break. I was known to buy a hundred at a time.
__________________
( R E T I R E D , and glad of it)
YES ! ! ! There is life after trucking.
a GOOD life
|
03-02-2010, 11:53 PM
|
Administrator
Site Admin
Board Icon
Join Date: Feb 2005
Location: Tennessee
Posts: 17,097
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 1 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
I don't know what happens to all those bungee's that I have bought over the years. They seem to disappear. I have added a few portable winches, 2" hand ratchets, 4" ratchets and a few other things along the way. One thing that I forgot is padding. A few pieces of carpet or felt works very well. If you are short of cash pampers also works well. Don't forget the duct tape.
|
03-03-2010, 03:32 AM
|
Senior Board Member
Join Date: Aug 2005
Location: jackassville (winnipeg, mb)
Posts: 3,280
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 1 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Here is an approximation of what I have:
Straps:
(15) 30'x4" straps with flat hook
(2) 40'x4" straps with flat hook
(1) 50'x4" strap with flat hook
(4) 30x4" straps with chain
(4) 30x2" straps with flat hook
Chains(I have 5/16 and would recommend 3/8):
(6) 6'
(8) 16'
(8) 25'
Binders:
11 Snap binders
20 "quik lok" snap binder locks - instead of using bungees
8 Ratchet binders
Tarps:
- 2 steel tarps (25x16 4 rows)
- front tarp (25x14 with flap, 4 rows on sides and flap, and two extra rows at the back - highly recommended)
- back tarp (25x16 with flap, 4 rows on sides and flap)
- "farmer" tarp - cheap POS I use for grader blade leading edges, 30' x 12'
- "smoke" tarp (10x10?)
Other:
- ~70 21" bungees
- ~70 15" bungees
- 4 portables (for straps with 4") flat hook
- 4 portables (for straps with 2") flat hook
- 30 edge protectors for straps
- 20 edge protectors for chains
- usually carry 8 pieces of dunnage (3"x3"x96")
- Various pieces of cardboard, carpet, rubber etc.. to protect tarps and loads
- 2 winch bars (never have just one!!!)
- headache rack - I recommend a custom enclosed that is as big as you can fit - trust me!
- 4 portable chain pockets - hard to explain, they snap in above the wheels on my step where there's nothing to chain to, East and Reitnouer use these)
- 2 load levelers
- Various pieces of rope
All this stuff basically completely fills up four 60" toolboxes plus my headache rack. I do plan on adding a bit more, portables with chains, more bungees, a few other odds and ends.
|
03-03-2010, 10:50 AM
|
Senior Board Member
Join Date: Oct 2005
Posts: 2,303
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 1 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
I carry a couple of moving blankets also for edge (tarp) protection. I made some edge protectors out of 1x6 and pieces of old straps that I had accumulated. Seems like you can never have enough edge protectors. I carry 12 pcs of 4x4x8 dunnage. There's been times I've used them all.
|
03-03-2010, 11:25 AM
|
Administrator
Site Admin
Board Icon
Join Date: Feb 2005
Location: Tennessee
Posts: 17,097
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 1 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Although you can start with 10 straps, I would have at least enough for each winch on the trailer and at least one or two extra in case one gets gets damaged. It is very easy to cut a strap if you don't properly protect it from sharp edges. Some flats can have as many as 15 winches. It is rare that you should need more than 10, but lately I have had to use 12 on one load and 13 on another. I would start with the basics and then add as needed. Everyone has a different business. If you mostly haul coils or steel, then your securement needs may be different than if you haul machinery or equipment.
|
03-03-2010, 12:05 PM
|
Senior Board Member
Join Date: Oct 2005
Posts: 2,303
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 1 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Yeah, I had 12 winches when I bought the trailer and added two more later on and sometimes I use them all. Man, if I could carry everything I wanted too I'd have to drag a little 28' pup trailer behind my flatbed.
|
03-03-2010, 02:44 PM
|
Board Icon
Join Date: Oct 2005
Location: Been there and gone...
Posts: 6,412
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 1 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 1 Thread(s)
|
Something else you will find helpful, though you can work with a flatbed for years without one.
A STRAP WINDER.
Cuts down your time rolling up your nylon straps for storage.
__________________
( R E T I R E D , and glad of it)
YES ! ! ! There is life after trucking.
a GOOD life
|
03-03-2010, 04:21 PM
|
Senior Board Member
Join Date: Jan 2006
Location: North East
Posts: 1,199
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 1 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Mentioned: 0 Post(s)
Tagged: 1 Thread(s)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Has anyone tried electric winches. The demo looked cool. Push a button and they tighten themselves.
|
|
|
|
|