Trucker Forum - Trucking & Driving Forums - Class A Drivers - Best way to remove stickers from a truck???

Page 2 of 2

Show 40 post(s) from this thread on one page

Trucker Forum - Trucking & Driving Forums - Class A Drivers (https://www.classadrivers.com/forum/)

- New Truck Drivers: Get Help Here (https://www.classadrivers.com/forum/new-truck-drivers-get-help-here-102/)

- - Best way to remove stickers from a truck??? (https://www.classadrivers.com/forum/new-truck-drivers-get-help-here/31076-best-way-remove-stickers-truck.html)

headborg

12-05-2007 06:33 AM

I was going to say to remove Placards ...you can spray Starting Fluid on them then light it with a cig lighter.....let it burn a little while then they scrape right off......makes a ugly black stain on the paint though.

Mr. Ford95

12-05-2007 09:58 AM

We use a heat gun, looks just like a hair dryer and basically is. Once we heat the sticker enough, it peels right off with your fingers but watch it, it's hot stuff. To finish getting all the sticky crap off and so you see no ghost lines, we use degreaser and a rag to wipe it all off.

BIG JEEP on 44's

12-05-2007 10:25 AM

Quote:

Originally Posted by headborg

Many of the million milers at Werner would use Crack pipe heat to remove placards... :wink:

USMC Vet

12-05-2007 11:07 AM

Quote:

Originally Posted by BIG JEEP on 44's

Quote:

Originally Posted by headborg

Many of the million milers at Werner would use Crack pipe heat to remove placards... :wink:

ROFLMAO, Big Jeep always comes through with a good one.

Howard

12-08-2007 02:09 PM

stickers

Use lacquer thinner on sticker ,then start on a corner pull or scrape off.Then use to old glue off

Fredog

12-08-2007 02:14 PM

Re: Best way to remove stickers from a truck???

Quote:

Originally Posted by Griff

Hey guys, anyone got any suggestions on removing truck company stickers off the truck??

http://i206.photobucket.com/albums/b...3_front200.jpg

best stuff ever made, made by the makers of wd40.

Mr. Ford95

12-09-2007 01:47 AM

GooGone does a good job of getting the left behind junk off.

happyhookin

12-09-2007 09:22 AM

Quote:

Originally Posted by roadhog

I use an eraser. You can get one from an Auto body supplier. They attach to a drill. Right angle drills are easiest to work with. It will scrub off the sticker and not harm the paint.

The paint is often brighter under the sticker, as the rest of the paint around it has faded. So, some compound buffing helps unify the appearance some.

I swear by these things, much easier than any other method I've tried. 3M makes them, they can be ordered at NAPA.

All times are GMT -12. The time now is 10:33 AM.

Page 2 of 2

Show 40 post(s) from this thread on one page