| View previous topic :: View next topic |
| Author |
Message |
csramsey640
Joined: 30 Sep 2006
Posts: 128
|
| Posted: Sat Oct 28, 2006 7:46 am Post subject: 2000 Freightliner Fault code at startup |
|
|
We have a 2000 Century class, n14. At startup you get this message that says something about system fault, or fault something #1.
Does anyone have an idea what this means? It only shows at startup. |
|
| Back to top |
|
marcel27208
Joined: 19 Aug 2006
Posts: 792
|
| Posted: Sat Oct 28, 2006 12:12 pm Post subject: |
|
|
| do u have a shtdwn overide button on Lft hand side near your left knee on the dash?? |
|
| Back to top |
|
csramsey640
Joined: 30 Sep 2006
Posts: 128
|
| Posted: Sat Oct 28, 2006 2:59 pm Post subject: |
|
|
| I honestly never looked. Truck is on route right now, but I will check. It only happens at key on, engine off and shows for a min or so. It goes right out at startup, and never comes back on at anytime. There is a check engine toggle, but it doesnt really do much, its located on the lower right area above the key |
|
| Back to top |
|
marcel27208
Joined: 19 Aug 2006
Posts: 792
|
| Posted: Sat Oct 28, 2006 5:18 pm Post subject: |
|
|
| i know on mine, when i start it up it always says "active fault 1" but when i check it with the shutdwn override button, its an old code that was never cleared out a few years back, and when i push in tractor brake button, it wont come on til the next morning when i go to start truck again, i have a 2000 freightliner century also. |
|
| Back to top |
|
csramsey640
Joined: 30 Sep 2006
Posts: 128
|
| Posted: Mon Oct 30, 2006 6:56 am Post subject: |
|
|
| OK, same here. How do you go through pulling codes on yours? I tried fooling around with it, and cant seem to get them to come up. (if there are any) |
|
| Back to top |
|
bob h
Joined: 15 Oct 2006
Posts: 664
Location: Nb
|
| Posted: Mon Oct 30, 2006 7:18 am Post subject: |
|
|
csramsey640 wrote: OK, same here. How do you go through pulling codes on yours? I tried fooling around with it, and cant seem to get them to come up. (if there are any)
Celect plus (N14) does not flash codes on the dash unless they are active (happening right now).
Not sure about century, it may be different, but normally you would turn the key switch on while holding the diagnostic (check engine) switch on, then release the switch and count flashes. |
|
| Back to top |
|
| |
Powered by phpBB 2.0.22 © 2001,2002 phpBB Group
|
|
Trucking
Companies | Trucking
Job Search | Online
Job Application | Trucking
Links | Truck Drivers
Message Board | Forum
Archives | Contact
Us | Site Map
Truck Driving Jobs
© 2003 ClassADrivers.com
Web Design
By CAD Website Design
| CAD Enterprises LLC |
