[Musicman]

I've spec'd this trailer to be as versatile as possible, and it's been a great performer over the last two years. Specs are as follows:

Upper Deck - 11'
Lower Deck - 42'
Lower Deck Loaded Height - 37"
30" Kingpin setting
Floor Crossmembers - 12" Centers
Rear Sliding 10' 1" Spread is California Legal
Haldex Scale-O-Matic with manual dump valve
Remote front airbag deflate from tractor
Meritor PSI Tire Inflation System
Michelin XTA 2 ENERGY 265 70R 19.5 (about 40%)
Brakes at about 90%
(2) 18" X 24" X 60" Boxes
(2) Reitnouer Load Leveler Sets (20k lb capacity per set)
(20) Reitnouer J-hooks
7-pin Accessory Plug
4-pin plug on rear of trailer
All LED Lighting
13 Lights per side
9 lights on back
Trailer is wired for flashing amber strobes (toggle on rear of trailer), but I removed them. I will include the amber strobes with the trailer
15 sliding winches can be mounted on both sides of trailer

The 4 piece ramp set ramp has a 23,500 lb per axle capacity, is 20" wide, with upper and lower deck brackets, as well as a kit that converts each ramp into a load leveler. I am willing to sell the ramps with the trailer, but won't mind removing them and using them on my new trailer if you want the Reitnouer minus the ramps.

I'm asking $39,500 without the ramps and $42,500 with the ramps.

[GMAN]

Nice looking trailer, Musicman. I hope you meant that the ramps have a 23,500 pound capacity rather than the trailer.

[Musicman]

Originally Posted by GMAN

Nice looking trailer, Musicman. I hope you meant that the ramps have a 23,500 pound capacity rather than the trailer.

Thanks GMAN. I think the wording was clear, but have rearranged it so there is no mistaking the meaning. I did, however, have the capacity misstated. It's 23,500 lbs per axle, not total.

I'm somewhat conflicted about selling the trailer. It's done well for me, and I've put a lot of work into assembling one of the most versatile setups around, but with developments in my home life, I think I need to get into a slightly lighter trailer to open up the the coil, lumber and steel markets I sometimes find myself (with my heavy tractor) excluded from. I've ordered a 2014 48' Fontaine Revolution 52 Step Deck that is supposed to roll off the assembly line in mid October.

Wouldn't my Reitnouer look good behind your tractor? I'll knock $500 off, just for you.